"Your fork is done!"
Can you tell Halloween comes early at our house?Fine custom bicycles handcrafted in New Mexico. Call 505 514 3010
A little extra miter work here: double compound miters on the seat tube and down tube. Why? No good reason other than it looks neat inside the BB shell. A lot of folks will just put the extra cut in the seat tube, and that's fine, it just won't look as cool later. Although, the only people who will ever see it are me and Jogn, but still.........
Seat tube brazed in here and getting one of the 40-50 alignment checks a frame gets through the build process. Nice and square here!
View from inside the BB after the downtube is brazed in- it's the little things......
Top tube mitered and fitted. I like to be able to rotate the frame for this braze, so the frame is clamped in a workstand that allows me to turn it whichever way I need.
A trip to the Morroni jig to get the chainstays fitted up. I love this huge chuck of machined steel, there's only one other jig like this in use today. But I do know where another one is sitting and can be had for a song!
A light-tight fit done with only a hacksaw and a file.
All brazed up! It looks like hell with the flux still on it, but trust me, it's a nice braze!
Lining up the angle with the blue print- spot on! If it were off, I'd have to cold set it (read: bend) something I absolutely hate to do and something I haven't had to do since my first frame. If the miter is right and the proper brazing sequence is followed, it will be right every time.
The seatstays will have the traditional caps- made from scratch to give it the custom flair. Because, as you must know, every custom has to have the required amount of flair.
A blurry pic of a scrap piece of seat stay brazed in place. I like to use this diameter because it gives the cap a more scalloped look.
Excess tube cut away and a bit of file work later......and we have our cap!
Laying the tubes against the blue print to balance the butted sections and make the marks for the rough cuts....looks like there's a rogue spider on there too!
Checking the downtube lug angle. This lug will have to be adjusted a bit as this frame has a taller fork (fender clearance) coupled with a higher BB (pedal clearance) that puts the lug about a half degree out of spec- well within adjustment (read: bending to fit) limits though.
Drop out mods underway.
Most agree the 370mm is too short for chainstays, this bike can run at 360. Head angle is 74 and the seat is an effective 73.
The seatstay angle looked funny if they were to attach to the top of the seat tube, so I stuck them on the top tube in fine Hellenic fashion -named for 1920's bike builder Fred Hellens so, no, GT did not pioneer this design! They aren't attached to the seat tube at all in order to take full advantage of any compliance they might offer.
My favorite part of this bike is the segmented fork- my first one that narrows at the top. I expect that I'll be using this fork long after I'm done testing this frame.